Works Bell908S - Short Hub (Boss Kit) MAZDA FD3S & MS9

PLEASE NOTE: This boss kit is only compatible with the coupler type horn wiring configuration as per the product image.

THIS BOSS KIT IS NOT COMPATIBLE WITH VEHICLES THAT HAD A FACTORY STEERING WHEEL PRESENT WITH A COPPER CONTACT RING ON ITS BACK (aka non coupler) 

For vehicles without the horn coupler, please see 902 or 902S model boss kit. This boss kit is not compatible with vehicles factory fitted with SRS airbag.

Racehub NZ is New Zealand's official distributor & authorised dealer for genuine Works Bell products direct from the manufacturer.

Works Bell has developed an exclusive short hub system that is designed for use with the Rapfix II quick release kit. This short hub system is designed to compensate for the additional length of the Rapfix II and prevents setting the steering wheel too close to the driver. With the short hub system, the user is able to offset the position of the steering wheel anywhere from 20mm-30mm (depending on the hub model used) AWAY from the driver for optimum driving position.

The Works Bell short hub can also but used as a regular boss kit and a steering wheel can be mounted on directly with or without a quick release kit.
These short hub kits are available in application specific models for Subaru, Toyota, Nissan, Mazda, Mitsubishi, Suzuki and various European models. Please see compatibility section for more detail on this listing.

SPECIFICATIONS:
Material: Billet Aluminum
Length (mm): 40
Length in comparison to standard Boss KIt (mm): -18

COMPATIBILITY NOTES:
- Momo Steering Wheel Pitch
Use 908S for:
- MS-8 MB5A without Airbag. Not compatible with ACC and SRS
- RX-7 FD3S without Airbag. Not compatible with ACC and SRS
- RX-7 FD3S with side coupler type connection

WARNING: ALL INSTALLATION MUST BE CARRIED OUT IN ACCORDANCE TO THE TORQUE SPECIFICATIONS FOUND INSIDE THE PACKAGING OF THIS PRODUCT.

ANY DAMAGE RESULTING FROM DEVIATION WILL NOT BE COVERED BY RACEHUB NZ.

PLEASE REFER TO A PROFESSIONAL TECHNICIAN IF YOU DO NOT HAVE THE APPROPRIATE TOOLS FOR INSTALLATION. MORE INFO BELOW:
https://www.worksbell.co.jp/en/support/tightening-torque/

COMPATIBILITY

Mazda MS-8 MB5A KL-ZE (01/1992-06/1998)
Mazda MS9 Efini Sentia HD5P J5-DE (03/1991-07/1998)
Mazda MS-9 HD5S J5-DE (03/1991-07/1998)
Mazda MS-9 HDEP JE-Z (03/1991-07/1998)
Mazda MS-9 HDES JE-ZE (03/1991-07/1998)
Mazda RX7 FD3S Type I 13B-REW (12/1991-09/1994)
Mazda RX-7 FD3S Type II 13B-REW (09/1994-03/1995)
Mazda RX-7 FD3S Type III 13B-REW (09/1994-01/1996)
Mazda RX-7 FD3S Type IV 13B-REW (01/1996-12/1998)